Getting Started with the VR Device

1. Power On

Remove the VR headset from its case. Long press the   POWER button on the bottom of the headset and wait for the Status Indicator LED to turn on a BLUE light.

Bottom View: 

 

2. Put on the Headset

Using one hand, hold the VR headset over your eyes in a comfortable position. If you wear glasses, you can wear them under the VR headset. The headset fits most standard glasses with a frame width of less than 160 mm.

3. Ensure a Comfortable Fit

Using your other hand, hold the battery pack at the back of the VR headset’s head strap and pull it down over the back of your head. If the head strap is too tight, loosen it by detaching the VELCRO® at the sides of the head strap, pulling the head strap until it is loose enough to fit around your head, and then reattaching the VELCRO.

4. Tight the Velcro Straps

Once the head strap is around your head, tighten the head strap by detaching the VELCRO at the sides of the head strap, pulling the ends of the head strap until it is sufficiently tight, and then reattaching the VELCRO. The VR headset should feel snug, but not uncomfortably tight.

5. Focus Your View

You can adjust the precise position of the VR headset on your face in order to see a clear image. This is done by moving the VR headset slightly up and down your face.

Look directly at the text and imagery so that it is centered in your field of vision. Move the VR headset slightly up and down your face until you find a position where the image and text on the screen is clear and visible. If necessary, tighten the head straps again to keep the VR headset in that position.

6. Ready to Start

The VR headset is now properly positioned on your head and is ready to be used.

7. Welcome Screen

Once you power up your headset for the first time, a series of onboarding screens will help guide you through: how to fit your headset properly, how to use our GAZE-BASED cursor, and how to connect to your WiFi. This onboarding includes a RelieVRx program overview and information on the first session in the program.

8. Select the VRx Session

Enter the VRx session by selecting the module tile on the Home menu.

This is a general example, your specific Virtual Reality experience may differ slightly.

Daily VRx Sessions.

Once you complete the VRx session, the next experience will automatically appear on the home screen. It is recommended that only one session is completed per day.

9. Power Down

At the end of the session, remove the headset, and long press the power button for a full 3 seconds until the screen goes black. To ensure the headset is charged and ready for your next use, make sure you plug the headset back into the USB-C charger.

NOTE: Store the headset in its protective box when not in use to prevent damage.